===Steps===
1. # Remove the rear headrests.2. # Remove the headrest inserts by prying the latch on the right side of the inside of the sleeve while popping it out with a screwdriver in the notch in the front of the sleeve. Fig. 1 shows the notch and latch.
[[file:9009-3Rearseat-1.jpg|thumb|Fig. 1 - Headrest insert showing notch and latch]]
3. # Remove the two screws holding the handle of the latch in place.4. # Pry up the piece of plastic that covers the right side of the cross bar.5. # Remove cable from lever on right side.6. # Remove the cable from one side of the latch cable carrier.7. # Modify nylon washer so that it doesn't take up too much slack and thread onto cable.
[[file:9009-3Rearseat-2.jpg|thumb|Fig. 2 - Modified washer]]
[[file:9009-3Rearseat-3.jpg|thumb|Fig. 3 - Washer, cable and cable cover]]
8. # Put cable back into carrier.9. # Reattach cable to lever on right side.10. # Put crossbar cover back in place.11. # Put screws back into handle.
