Changes
From The Saab Tech Wiki
1. Turn the ignition switch to the OFF position and remove the battery.
[[file:Sensonic_Actuator_01.gif|thumbnail|none|Charge Pipe, Power Steering Reservoir, Clutch Actuator]]
2. Remove the pressure pipe between the charge air cooler and throttle body and seal the hose to prevent dirt from entering it.
8. Unscrew the bolts securing the battery tray.
[[file:Sensonic_Actuator_02.gif|thumbnail|none|Battery Tray and Clutch Actuator]]
9. Remove the remaining bolts securing the CA unit.
12. Remove the two screws securing the master cylinder.
[[file:Sensonic_Actuator_03.gif|thumbnail|none|Master Cylinder and Clutch Actuator]]
13. Remove the clip securing the pressure pipe to the CA unit's holder.
[[file:Sensonic_Actuator_04.gif|thumbnail|none|Clutch Actuator]]
14. Lift out the CA unit.
1. Position the clutch actuator unit and fit the clip securing the pressure pipe to the CA unit's holder.
[[file:Sensonic_Actuator_05.gif|thumbnail|none|Clutch Actuator]]
2. Replace the two screws securing the master cylinder to the CA unit.
[[file:Sensonic_Actuator_06.gif|thumbnail|none|Replace Screws Securing Master Cylinder to Clutch Actuator]]
3. Fit the maxifuse fuse box back in place.
[[file:Sensonic_Actuator_07.gif|thumbnail|none|Rebolt Clutch Actuator and Battery Tray]]
4. Tighten the screws securing the clutch actuator unit.
7. Fit the wiring harness in place, press the connectors into the holder and tighten the holder's three retaining screws.
[[file:Sensonic_Actuator_08.gif|thumbnail|none|Reassembly]]
8. Plug in the three sensor connectors.
