=Removal=
1. Turn the ignition switch to the OFF position and remove the battery.
[[file:Clutch_Actuator_With_Master_Cylinder_01.gif|thumbnail|none|Removing charge pipe, moving power steering fluid reservoir and unplugging correctors]]
2. Remove the pressure pipe between the charge air cooler and throttle body and seal the hose to prevent dirt from entering it.
8. Unscrew the bolts securing the battery tray.
[[file:Clutch_Actuator_With_Master_Cylinder_02.gif|thumbnail|none|Remove bolts securing battery tray and clutch actuator]]
9. Remove the remaining bolts securing the CA unit.
13. Undo the master cylinder's pressure pipe and collect the two sealing washers.
[[file:Clutch_Actuator_With_Master_Cylinder_03.gif|thumbnail|none|Disconnecting lines from master cylinder]]
14. Disconnect the master cylinder's feed hose.
16. Lift out the CA unit.
[[file:Clutch_Actuator_With_Master_Cylinder_04.gif|thumbnail|none|Clutch Actuator]]
=Replacement=
1. Correctly position the clutch actuator unit and fit the clip securing the delivery pipe to the actuator unit's holder.
[[file:Clutch_Actuator_With_Master_Cylinder_05.gif|thumbnail|none|Position clutch actuator and connect lines]]
2. Reconnect the master cylinder's feed hose.
5. Tighten the screws securing the clutch actuator unit.
[[file:Clutch_Actuator_With_Master_Cylinder_06.gif|thumbnail|none|Screw in actuator, secure battery tray and plug in clutch actuator connector]]
6. Fit the bolts securing the battery tray.
8. Fit the wiring harness in place, press the connectors into the holder and tighten the holder's three retaining screws.
[[file:Clutch_Actuator_With_Master_Cylinder_07.gif|thumbnail|none|Connect wiring harness, plug in sensor connectors, refit power steering reservoir and refit delivery pipe]]
9. Plug in the three sensor connectors.