===Steps===
# 1. Remove the rear headrests.# 2. Remove the headrest inserts by prying the latch on the right side of the inside of the sleeve while popping it out with a screwdriver in the notch in the front of the sleeve. Fig. 1 shows the notch and latch.
[[file:9009-3Rearseat-1.jpg|thumb|none|Fig. 1 - Headrest insert showing notch and latch]]
# 3. Remove the two screws holding the handle of the latch in place.# 4. Pry up the piece of plastic that covers the right side of the cross bar.# 5. Remove cable from lever on right side.# 6. Remove the cable from one side of the latch cable carrier.# 7. Modify nylon washer so that it doesn't take up too much slack and thread onto cable.
[[file:9009-3Rearseat-2.jpg|thumb|none|Fig. 2 - Modified washer]]
[[file:9009-3Rearseat-3.jpg|thumb|none|Fig. 3 - Washer, cable and cable cover]]
# 8. Put cable back into carrier.# 9. Reattach cable to lever on right side.# 10. Put crossbar cover back in place.# 11. Put screws back into handle.