Changes
From The Saab Tech Wiki
Boost Pressure Control (BPC) is how the engine ecu controls and limits turbo boost. Same function as APC on older Saabs, but performed directly by the ecu. With no boost pressure control, boost would be regulated by the spring inside the waste gate actuator. It would only reach 0.4 bar, or about 6 psi. This is also called "base" boost. The Boost Pressure Control (BPC) Valve is used to control the level of boost above 0.4 bar. On a stock engine (with no modifications), the maximum boost level is set to 0.8 bar, or between 12 and 13 psi.
[[file:900_9-3_BPC_6.gif|thumbnail|none|Fig. 1 - BPC Location Diagram]] [[file:900_9-3_BPC_1.jpg|thumbnail|none|Fig. 2 - BPC Location Pictures]]
===Overboost and Fuel Cut===
===Electrical Test===
The resistance of the two solenoid coils can be measured to see if a coil has burned out or shorted. To test, unplug the electrical connector and measure across pins 1 and 2, and also across 2 and 3. In both cases, the resistance of a good coil is about 3 ohms. If not, the valve should be replaced.
[[file:900_9-3_BPC_7.gif|thumbnail|none|Fig. 3 - BPC Pins]]
===Hoses===
The valve has three hose connections. Turbo compressor, which is the source of air pressure, waste gate actuator, which is operated by the air pressure, and the air intake which is used to bleed off air above base boost. The valve is normally open from the compressor to the waste gate, and closed to the intake. Above 0.4 bar, the ecu cycles the BPC solenoid to open the valve to the intake and bleed off some of the boost air from the waste gate actuator, which allows the waste gate to open at a higher pressure. The hose connections are marked C, W and R on the valve.
See Fig. 3
C - from turbo Compressor to the BPC valve
W - from BPC valve to Waste gate actuator
R - pressure Reduction port, back to the air intake
==Removal and Cleaning==
===Access===
The BPC valve is located in the front of the engine compartment close to the RH side headlight. The electrical connector and the ends of the three hoses are easily accessible. Mark the hoses before disconnect them from the valve, because they have to be put back in the same order. (See blue mark on hose at left).
[[file:900_9-3_BPC_5.jpg|thumbnail|none|Fig. 4 - BPC]]
===Removal===
The valve can be removed after unplugging the electrical connector, and removing two torx head screws. The screws are held by rubber bushings with metal inserts. If the screws do not come out easily, it may be necessary to remove the headlight and push them out from behind.
[[file:900_9-3_BPC_4.jpg|thumbnail|none|Fig. 5 - BPC and Hoses]]
===Cleaning===
The picture below shows one screw which could not be separated from the bushing insert. If the valve is clogged by oil or dust and causing overboost and fuel cut, it can usually be cleaned by blowing compressed air into the ports, using a can of compressed "dry" air from an office supply store. If the valve is clogged by oil residue, using solvent (isopropyl alcohol, electrical contact cleaner, carb cleaner) may be necessary as a last resort.
[[file:900_9-3_BPC_3.jpg|thumbnail|none|Fig. 6 - BPC]]
