http://www.saabwiki.info/index.php?title=NG_900/9-3_Green_Roller&feed=atom&action=historyNG 900/9-3 Green Roller - Revision history2024-03-28T18:08:16ZRevision history for this page on the wikiMediaWiki 1.24.2http://www.saabwiki.info/index.php?title=NG_900/9-3_Green_Roller&diff=302&oldid=prevMbcullen: Created page with '==Overview== The green rollers that connect the scissor lift to the window in the front door of the 900 and 9-3 break frequently, usually resulting in the window falling into the…'2009-11-18T23:45:41Z<p>Created page with '==Overview== The green rollers that connect the scissor lift to the window in the front door of the 900 and 9-3 break frequently, usually resulting in the window falling into the…'</p>
<p><b>New page</b></p><div>==Overview==<br />
The green rollers that connect the scissor lift to the window in the front door of the 900 and 9-3 break frequently, usually resulting in the window falling into the window frame. They are easy to replace, and fairly inexpensive. <br />
<br />
==Repair==<br />
<br />
===Tools===<br />
* Latex gloves<br />
* Torx drivers - for removing door panel<br />
* Pin - to pop out plastic pin on end of door panel<br />
* Grease<br />
* Paper towels<br />
<br />
===Parts===<br />
* 2 new green window roller<br />
<br />
===Steps===<br />
<br />
# Remove screws from door panel. There are six total - 1 behind the door handle, two behind the door pull, three at the very bottom of the door.<br />
# Remove the plastic retainer above the door latch. With some skill and luck you can pull out the center pin with a needle in order to reuse it. Otherwise it breaks and you get to buy an overpriced replacement from the dealer.<br />
# Pull off the door panel with a slight counterclockwise twist to get it over the lock and out from under the under the sail.<br />
# Remove the outer foam from the door without tearing it.<br />
# Remove the inner foam from the door without tearing it.<br />
# If necessary, pry the pins out of the broken green rollers to remove the old rollers from the metal track in the window. <br />
# Remove green rollers from window. <br />
# Position the window in the tracks and make sure that the weather stripping is correctly positioned.<br />
# Slide the window up and down to make sure it is properly seated in the tracks.<br />
# Clean old grease out of the window track. <br />
# Grease the track and put your new green rollers in.<br />
# Use the window regulator to set the scissor lift at a height that you can reach behind the window and press it into the rollers with the heel of your hand.<br />
# Pop the scissor lift into the rollers until you get to the first click.<br />
# Move the window up and down a few inches to make sure everything is operating smoothly.<br />
# Press the scissor lift into the green rollers until you get a second harder, louder click.<br />
# Put both pieces of foam back on the door.<br />
# Roll the door panel back into position, clockwise.<br />
# Position the door panel so that the plastic rivet things line up with their holes.<br />
# Press the door panel in place.<br />
# Put door handle in position and test it.<br />
# Put all of your screws back into place.</div>Mbcullen