2,227 bytes added,
23:45, 18 November 2009 ==Overview==
The green rollers that connect the scissor lift to the window in the front door of the 900 and 9-3 break frequently, usually resulting in the window falling into the window frame. They are easy to replace, and fairly inexpensive.
==Repair==
===Tools===
* Latex gloves
* Torx drivers - for removing door panel
* Pin - to pop out plastic pin on end of door panel
* Grease
* Paper towels
===Parts===
* 2 new green window roller
===Steps===
# Remove screws from door panel. There are six total - 1 behind the door handle, two behind the door pull, three at the very bottom of the door.
# Remove the plastic retainer above the door latch. With some skill and luck you can pull out the center pin with a needle in order to reuse it. Otherwise it breaks and you get to buy an overpriced replacement from the dealer.
# Pull off the door panel with a slight counterclockwise twist to get it over the lock and out from under the under the sail.
# Remove the outer foam from the door without tearing it.
# Remove the inner foam from the door without tearing it.
# If necessary, pry the pins out of the broken green rollers to remove the old rollers from the metal track in the window.
# Remove green rollers from window.
# Position the window in the tracks and make sure that the weather stripping is correctly positioned.
# Slide the window up and down to make sure it is properly seated in the tracks.
# Clean old grease out of the window track.
# Grease the track and put your new green rollers in.
# Use the window regulator to set the scissor lift at a height that you can reach behind the window and press it into the rollers with the heel of your hand.
# Pop the scissor lift into the rollers until you get to the first click.
# Move the window up and down a few inches to make sure everything is operating smoothly.
# Press the scissor lift into the green rollers until you get a second harder, louder click.
# Put both pieces of foam back on the door.
# Roll the door panel back into position, clockwise.
# Position the door panel so that the plastic rivet things line up with their holes.
# Press the door panel in place.
# Put door handle in position and test it.
# Put all of your screws back into place.