no edit summary
+4
no edit summary
+3
Created page with '1. Remove the battery. 2. Remove the cap on the CA unit and check that the CA unit's worm gear is in the engaged position (position E). If it is not, rotate it to the engaged po…'
Ensure Worm Gear is in Engaged Position
no edit summary
+82
Manual Transmission Cutaway
Transmission Position
Created page with '=Overview= The gearbox is designed for front wheel drive and forms a unit with the engine. The drive unit is transversely mounted in the car, which gives good cooling and the sho…'
no edit summary
+43
no edit summary
+444
no edit summary
+203
no edit summary
+367
Chain Tensioner
Camshaft Cover
Throttle Body Preheat Hose
Remove Dipstick Tube
Unplug DIC
Crankcase Breather Valve and Inlet Pipe
Release Serpentine Belt Tension
MAF; Turbo by-pass and inlet; Delivery Pipe
Created page with '1. Drape protective covers over the wings to protect the paintwork, drain the coolant and disconnect the negative battery cable. 2. Unplug the mass air flow sensor connector and…'
no edit summary
+61
no edit summary
+40
no edit summary
+126
no edit summary
no edit summary
+982
Alternator and Starter
Lift Engine Off Stand
Fitting Transmission
Intake Manifold
Water and Oil Pipes, and Engine Mounting Bracket
Exhaust Manifold and Oil Filter Adapter Housing
Crankshaft Pulley
Camshaft Cover, Spark Plugs and DIC
Chain Tensioner
Camshafts
Cylinder Head Bolts
Fitting the Oil Pump
Fitting the Timing Cover
Timing Chain Guide
Timing Chain Tensioner
Timing Chain Guide
Balance Shaft
Fitting Flywheel
End Plate
Compression Rings
Fitting Crankshaft
Fitting Engine Bearings